Brians Series Harness Set-up!
The purpose of a Series Harness is to wire two batteries together doubling the voltage, while keeping the capacity the same. For Example, two 3s 2200mah batteries wired in series create a 6s 2200mah battery. The black wire coming from the female connector goes to the negative side of the first battery. The positive side of that battery goes to the negative side of the second battery, and then finally the positive side of the second battery goes to the positive side of the female connector which then plugs into the Speed Control. See? That wasn’t that hard! Just a note...it is better to charge each battery separately, and balance each battery for maximum performance and longevity.
Click Below For Products:
Deans Ultra Plug, Female(2) WSD1303
Deans Ultra Plug Male(2) WSD1302
12 Gauge Silicon wire set (2 ft. Black, 2 ft. Red)
|
