2221-8 (3595 kv) : Similar to stock, more torque with same pinion. About the same flight ttimes as stock setup w/13 tooth pinion. 15 tooth pinion increases headspeed, but decreases flight time.

2221-6 (4440 kv) : 845 kv more that thee 2221-8. This is the super hot, 3D setup. Using the 11 tooth pinion, it is radical, and using the 12 tooth pinion, it is insame. Make sure your heli can handle the high headspeed. Expect more heat on the motor and batteries with this setup also.

3026-1600 (1600 kv) : Use this motor for the 6-cell setup using the stock 13 tooth pinion. Again, more toque and power than stock

3026-1900 (1900 kv) : Use this motor if your want to use the 5-cell setup. Also use the 13 tooth pinion (not 15 tooth). This motor has a higher kv than the stock Align motor. If you use the 15 tooth you will load this motor too much and not attain efficiency.

3730-1100 (1100 kv): Use for thee 6-cell setup. 16 or 17 tooth pinion recommended. This is a direct replacementt for your stock motor. No frame mods required. Much more torquee than the stock motor.

4025-890 (890kv) : Here is the "Wild" 8-Cell setup from Lucion at Innovative. Your MUST cut and reinforce the frames for this mod, but it's worth it if you want a hot rod. Use the 14 tooth pinion on this motor for optimum performance.

4025-740 (740kv) : This is the "INSANE" 8-cell setup from Lucin at Innovative. Again, as mentioned above, you MUST cut and reinforce the frames to get this "bad boy" mounted. With a 17 tooth pinion this mode will leave you with a "nuts crazy" T-Rex. Noboy will touch you.